Cisco Cisco ASR 5000 Application Detection and Control Administration Guide Manuel d'instructions télécharger pdf (Page 216)

System Features

INTER-TEL

5000 ADMINISTRATOR GUIDE – Issue 2.3, September 2007

Page 198 Exiting and Re-Entering the Conference

Exiting and Re-Entering the Conference

To exit the conference and leave the other parties connected (any inside party) with an

Inter-Tel endpoint:

During the conference, press the button and hang up. The button and a Call

button flutters

If all remaining parties are outside parties and the Hold timer expires while you are out of the

conference, the conference recalls your endpoint. The recall rings at your endpoint and the

button flashes at the medium rate. The display shows CONFERENCE RECALLING.

Press the button to return to the conference. If the recall is not answered before the

Recall timer expires, it will recall the attendant.

To return to the conference:

Lift the handset and/or press the button again.

To exit the conference and leave the other parties connected (any inside party) with a sin-

gle line endpoint:

During the conference, hookflash and hang up. If the Hold timer expires while you are out of

the conference, the parties recall your endpoint. When the recall rings at your endpoint, lift the

handset to answer the recall. If the recall is not answered before the Recall timer expires, it will

recall the attendant.

To return to the conference:

Lift the handset and/or enter the Conference feature code (5).

Ending the Conference and Placing All Parties on Hold

To end the conference and put all parties on hold (any inside party) with an Inter-Tel

endpoint:

During the conference, press the button and hang up. The button and a

Call button flutters. The parties are still connected in a conference.

To place the parties on individual hold: Press the Hold button or enter the Individual

Hold feature code (336). You can then return to each party individually by pressing the

associated Call or button.

To end the conference and put all parties on hold (any inside party) with a single line end-

point:

During the conference, hookflash and hang up. The parties are still connected in a con-

ference.

To place the parties on individual hold: Lift the handset and enter the Individual Hold

feature code (336). You can then return to each party individually by entering the Indi-

vidual Hold feature code again.

CNF

1 2 ... 211 212 213 214 215 216 217 218 219 220 221 ... 395 396

Pas de commentaire

Cisco Cisco ASR 5000 Application Detection and Control Administration Guide Manuel d'instructions Page 216