Cisco 678 Spécifications télécharger pdf (Page 98)

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices

Configure the WAN Ports and ATM Virtual Connections

5-14

Cisco 600 Series Installation and Operation Guide

78-11190-01

Step 3

To enable the wan0-0 connection, enter:

set interface wan0-0 enable

Step 4

To begin using this connection with the new settings, enter:

set interface wan0-0 open

Step 5

Repeat steps 2 through 4 for every VPI assignment you want to make.

Step 6

To save the new WAN port configuration, enter:

write

Step 7

To exit CBOS, enter:

quit

Changing VCI Settings

Step 1

To make sure the wan0-0 connection remains closed during configuration, enter:

set interface wan0-0 disable

Step 2

To set the VCI number to 4, enter:

set interface wan0-0 vci 4

Note

If you try to enter the command

set interface wan0-0

on a

connection that is already open, the system prompts you to

close that connection before you change the VCI setting. To

do this, enter the command

set interface wan0-0 close.

Step 3

To enable the wan0-0 connection, enter:

set interface wan0-0 enable

Step 4

To begin using this connection with the new settings, enter:

set interface wan0-0 open

Step 5

Repeat steps 2 through 4 for every VCI assignment you want to make.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 191 192

Pas de commentaire

Cisco 678 Spécifications Page 98