Cisco 678 Spécifications Page 102

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 192
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 101
Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices
Configure Applications
5-18
Cisco 600 Series Installation and Operation Guide
78-11190-01
Configure Applications
The Cisco 67x supports these applications for system management and control:
DHCP client
DHCP server
NAT
RADIUS client
SNMP
SYSLOG client
Telnet server
TFTP server
Web server (HTTP server)
DHCP Client
The DHCP client requests an IP address from a DHCP server. To enable the DHCP
client:
Note
Enabling the DHCP client automatically disables the DHCP server
on the CPE.
Step 1
Enable the DHCP client:
set dhcp client enabled
Step 2
To change the DHCP client interface, enter:
set dhcp client interface eth0
Step 3
To check whether this feature is enabled, enter:
show dhcp client
Step 4
Write the changes to NVRAM:
write
Vue de la page 101
1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 191 192

Commentaires sur ces manuels

Pas de commentaire