Cisco 10008 Guide d'installation télécharger pdf (Page 30)

Use the following procedure to connect a video terminal to the console port on a PRE:

Figure 23 Console Port Connection on the PRE

Step 1 Connect one end of the RJ-45 crossover cable to the serial RJ-45 port (CONSOLE) on the PRE.

Step 2 Run the cable up and through the cable-management bracket and connect the other end of the RJ-45 crossover cable

to the RJ-45 adapter (Figure 24). If your terminal is equipped with a DB-25 serial connector, use the RJ-45-to-DB-25

adapter. If your terminal is equipped with a DB-9 serial connector, use the RJ-45-to-DB-9 adapter.

Figure 24 Connecting an RJ-45-to-DB-9 Console Cable Adapter

Step 3 Connect the adapter to your video terminal to complete the cable connection.

Step 4 Power on your video terminal.

Step 5 Configure your video terminal to match the following default console port settings:

• 9600 baud

• 8 data bits

• No parity generation or checking

• 1 stop bit

• No flow control

30027

ONSO

ETHERNET

LIN

AUX

SLO

T 0

SLO

T 1

CISCO

10000

LINK

30028

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Pas de commentaire

Cisco 10008 Guide d'installation Page 30