Cisco Linksys WAG160N Guide de l'utilisateur télécharger pdf (Page 9)

Chapter 3

Installation

Wireless ADSL2+ Modem Router

Chapter 3:

Installation

Run the Setup CD-ROM to install the Modem Router. If you

have problems running the Setup CD-ROM, refer to this

chapter.

Connection

Make sure that all the devices that you are working with 1.

are powered down, including your computer(s) and

the Modem Router. If you have a modem connected

to your network, disconnect it. The Modem Router

replaces your modem.

Connect one end of the provided Ethernet cable to 2.

your computer’s Ethernet adapter. Connect the other

end of the Ethernet cable to one of the Ethernet ports

on the back of the Modem Router.

Connect the Computer

Repeat step 2 for every computer or device that you 3.

want to connect to the Modem Router via Ethernet. If

you connect more than four computers to the Modem

Router, you also need to connect a switch to the

Modem Router.

NOTE: If your computer’s Ethernet adapter

is not set up, refer to the Ethernet adapter’s

documentation for more information.

Connect one end of the phone cable to the DSL port 4.

on the back of the Modem Router.

Connect the DSL

Connect the other end of the phone cable to the wall 5.

jack with ADSL service or microfilter.

NOTE: To avoid interference, you may need

to place a microfilter or splitter between the

phone cable and wall jack. Contact your ISP to

determine if one is required. (UK residents need

to connect the microfilter to the wall phone jack

with ADSL service and then connect one end

of the provided phone cable to the DSL port

on it.) If you have more than one phone and

you experience static on the line after installing

the Modem Router, then you need to install an

additional microfilter for each phone or fax that

you use. If you use ISDN, then you do not need a

microfilter.

Connect the power adapter to the Modem Router’s 6.

power port and the electrical outlet.

Connect the Power

Power on the computer that you want to use to 7.

configure the Modem Router.

The Power, Wireless, and at least one of the numbered 8.

Ethernet (1, 2, 3, or 4) LEDs should light up. If not, make

sure the Modem Router is powered on and the cables

are securely connected.

Connection is complete.

Continue to the “Setup” section.

Setup

For setup, configure the Modem Router to access the

Internet through your ADSL Internet Service Provider

(ISP). Use the setup information provided by your ISP.

Access the web-based utility as described in Chapter

4: Advanced Configuration and then complete the

following tabs within the utility:

Setup > Basic Setup •

Wireless > Basic Wireless Settings •

Wireless > Wireless Security •

After completing the setup, to test it, enter

www.linksysbycisco.com/support in the web browser’s

Address field, and press Enter.

Installation is complete.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 95 96

Commentaires sur ces manuels

Pas de commentaire

Cisco Linksys WAG160N Guide de l'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs Cisco Linksys WAG160N