Cisco SG200-26 Manuel télécharger pdf (Page 4)

4 200 Series Smart Switches

PoE is available on the following ports:

Use the following table to determine the total power budget available for

all devices on your switch.

Configuring the Cisco Small Business

Smart Switch

Before You Begin

Verify that a computer with Microsoft Internet Explorer (version 6 or higher)

or Firefox (version 2.0 or higher) is available.

Accessing and Managing Your Switch Using the Web-

Based Interface

In order to access the switch with a web-based interface, you must know

the management IP address of the switch. The default configuration of the

switch is to use its factory default IP address of 192.168.1.254 until it has

obtained an IP address from a DHCP server, or it has been changed to a

static IP address.

When the switch is using the factory default IP address, its System LED

flashes continuously. When the switch is using a DHCP assigned IP

address or an administrator configured static IP address, the System LED

lights steady.

NOTE If the smart switch IP address is changed, either by a DHCP server

or manually, your access to the smart switch will be lost and you must

use the new IP address to configure the device.

To configure the smart switch:

STEP 1 Power on the computer and the switch.

STEP 2 Connect the computer to the switch. You can connect to the same

IP subnet as the switch by connecting them directly with an

Model Ports

SF200-24P and SG200-26P 1—6 and 13—18

SF200-48P and SG200-50P 1—12 and 25—36

Model Power Dedicated to PoE

SF200-24P 100 Watts

SF200-48P 180 Watts

SG200-26P 100 Watts

SG200-50P 180 Watts

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Cisco SG200-26 Manuel Page 4