Cisco ME 3400 Guide d'installation télécharger pdf (Page 5)

Step 5

Connect the switch to a power

source.

Typical power consumption =

25 W

Maximum power consumption =

40 W

This illustration shows the Cisco ME

DC switch. Connect one end of the

suppliedDC power cord tothepower

connector on a switch front panel.

Connect the other end of the power

cable to a DC outlet.

For detailed instructions to connect

to a DC power source, see the

“ConnectingtoDCPower” appendix

in the switch hardware installation

guide available on cisco.com.

Note Use only one of the ground connections,

either the one on the front panel or the

one on the rear panel.

To order spare or replacement DC connectors, use

one of these sources:

• Digi-Key, part number 277-1013-ND,

www.digikey.com

• Phoenix Contact, part number 1757035,

www.phoenixcontact.com

Step 6

Power on the switch using either the AC power cord or the DC power connector as

appropriate.

Step 7

Wait for the switch to complete the

POST.

It might take several minutes for the switch to

complete POST.

Step 8

Verify that POST has completed by

confirming that the System LED

rapidly blinks green. If the switch

fails POST, the System LED turns

amber.

POST errors are usually fatal. Call Cisco Systems

immediately if your switch fails POST.

Step 9

Wait for the switch to complete flash

initialization. When you see the

prompt Press Return to Get Started!,

press Return or Enter.

Press RETURN to get started!

Step 10

Go to the “Completing the Initial Configuration” section on page 6 to continue.

Cisco ME 3400

SERIES

INPUT -36 – -72 V

CURRENT 2 – 1A

CONSOLE

11X

12X

13X

14X

23X

24X

SYSTEM

132848

1 2 3 4 5 6 7 8 9 10 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Cisco ME 3400 Guide d'installation Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau Cisco ME 3400