Cisco WAP300N Guide de l'utilisateur télécharger pdf (Page 16)

Setting Up: Basics

Linksys WAP300N

Number of Wireless Networks—The number of wireless networks that

were detected.

Wireless Network Name—The network name (SSID) of each discovered

wireless network.

Signal—The percentage of signal strength.

Security—The security method used by each wireless network. If the

network supports Wi-Fi Protected Setup, the Wi-Fi Protected Setup icon

appears next to the security method.

Refresh—Updates the on-screen information.

To connect to a wireless network, select the network, then click Connect.

A screen opens that shows you the network name (SSID) and security

mode of the selected wireless network. Depending on the security mode

of the network, you may be asked to enter additional information (see

the following table).

Security mode

Information

Required Description

WPA/WPA2

Personal

Passphrase

Enter the passphrase shared by this

device and your wireless router (or

access point).

WEP

Encryption

Select a level of WEP encryption, 40 /

64-bit (10 hex digits) or 104 / 128-bit

(26 hex digits).

Key 1

Enter the WEP key of your network.

Key 1 is the transmit key used by this

device.

Authentication

The default is Auto, which allows

either open system or shared

key

authentication to be used.

Select Open to use open system

authentication (a WEP key is not used

for authentication). Select Shared to

use shared key authentication (a WEP

key is used for authentication).

After you have entered all required information, click Connect to connect

to the network.

How to use Wi-Fi Protected Setup

If your wireless router or access point supports Wi-Fi Protected Setup, you can

use it to easily connect your WAP300N to your wireless router or access point.

You can use two methods for Wi-Fi Protected Setup:

• Press the Wi-Fi Protected Setup button on each device

• Enter the WAP300N’s Wi-Fi Protected Setup PIN onto the router or access

point.

To manually configure your network, see “How to manually set up your

WAP300N” on page 14).

How to connect to a router or access point using the Wi-Fi

Protected Setup button

Use this method to connect your WAP300N to a router or access point by

pressing buttons on the two devices.

To connect to your router or access point using the Wi-Fi Protected

Setup button:

Press the Wi-Fi Protected Setup button on the back of the router or

access point.

Within two minutes, press the Wi-Fi Protected Setup button on the

back of the WAP300N.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Cisco WAP300N Guide de l'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Points d'accès WLAN Cisco WAP300N