Cisco OSM-12CT3/T1 - Optical Services Module Multiplexor Guide d'installation télécharger pdf (Page 26)

Chapter 1 Product Overview

Catalyst 6000 Family Modules

1-26

Cisco 7600 Series Internet Router Module Installation Guide

78-12798-07

FlexWAN Module (WS-X6182-2PA)

Note The FlexWAN module is not fabric-enabled. When a Switch Fabric Module is

installed in the Cisco 7600 series Internet Router, and there is a mix of

fabric-enabled and non-fabric-enabled (classic) modules in the system, the

central forwarding performance remains at 15 Mpps.

The MSFC2, in conjunction with the FlexWAN module (WS-X6182-2PA),

provides multiprotocol routing support with full Internet route connectivity for

speeds ranging from serial RS-232 to OC-3. The FlexWAN module can accept up

to two Cisco 7200/7500 WAN port adapters, which deliver WAN consolidation

and extend QoS and traffic management capabilities over WAN segments. The

FlexWAN module supports ATM and Packet over SONET (POS) OC-3 links and

channelized, multichannel, and clear channel port adapters at speeds from T1/E1

to T3/E3.

The STATUS LED on the FlexWAN module front panel (see Figure 1-20)

indicates the status of the FlexWAN module and is described in Table 1-15 on

page 1-30.

For information on FlexWAN module hardware and software requirements,

supported and unsupported features, and port adapter installation and

configuration, refer to the Catalyst 6000 Family FlexWAN Module Installation

and Configuration Note.

Figure 1-20 FlexWAN Module Front Panel (WS-X6182-2PA)

STATUS

30178

STATUS LED

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Pas de commentaire

Cisco OSM-12CT3/T1 - Optical Services Module Multiplexor Guide d'installation Page 26