Cisco IDS 4210 - Intrusion Detection Sys 4210 Sensor Fiche technique télécharger pdf (Page 41)

9E0 - 100

Leading the way in IT testing and certification tools, www.testking.com

- 41 -

 idsvers - To verify the installation of the S10 signature pack, Telnet to the Sensor, log on

as netrangr, and issue either the nrvers or the idsvers command.

 cidServer version – If you are having difficulty connecting to the sensor via the IDS

Device Manager, SSH or Telnet to the sensor and type the cidServer version command to

check the version and status of the sensor (whether it is running):

Reference:

Cisco Secure Intrusion Detection System Internal Architecture

Cisco IDS Sensor Software - Cisco Intrusion Detection System Sensor Getting

Started Version 3.1

Updating IDS Appliance Signatures and Troubleshooting Basic Communication

QUESTION NO: 79

TestKing International has decided to deploy a Cisco IDS solution. They have purchased

a Cisco IOS 4235 Sensor which has never been configured. You will have to configure

and initialize the Sensor to communicate with the Cisco IDS Director using the

information listed in the following table:

Cisco IDS Paramaters Settings

Sensor Host ID 4

Sensor Organization ID 27

Sensor Host Name sensor27

Sensor Organization Name HQ

Assignment: Click on the picture of the host connected to an IDS Sensor by a serial

console cable shown in the diagram as a dotted line. Select the Cisco Terminal Option

and make the appropriate configuration tasks.

Sensor IP address 192.168.1.4/24

IDS Manager Host ID 4

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 69 70

Pas de commentaire

Cisco IDS 4210 - Intrusion Detection Sys 4210 Sensor Fiche technique Page 41