Cisco NPE-G2 - Network Processing Engine G2 Guide d'installation télécharger pdf (Page 14)

7-14

Network Processing Engine and Network Services Engine Installation and Configuration

OL-4448-08

Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information

Removing the Network Processing Engine

Figure 7-4 Removing the Strain-Relief Cover from a Cisco uBR7246VXR DC-Input Power Supply

Step 4 Using a 3/16-inch flat-blade screwdriver, loosen the screw below the +V lead receptacle and pull the lead

from the connector. Repeat this step for the –V lead only. See Figure 7-5.

1 Power switch 6 –V lead

2 Power receptacle 7 +V lead

3 Captive screw 8 Strain-relief cover

4 M5 grounding receptacles 9 M4 nuts and studs

5 M5 grounding lug

66408

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 65 66

Pas de commentaire

Cisco NPE-G2 - Network Processing Engine G2 Guide d'installation Page 14