Cisco Fourth-Generation Versatile Interface Processor VIP4 Spécifications télécharger pdf (Page 39)

CHAPTER

2-1

Cisco PA-FE-TX and Cisco PA-FE-FX Fast Ethernet 100BaseT Port Adapter Installation and Configuration

OL-2899-02

Preparing for Installation

This chapter describes the general equipment, safety, and site preparation requirements for installing the

PA-FE-TX or PA-FE-FX port adapter. This chapter contains the following sections:

• Required Tools and Equipment, page 2-1

• Minimum Software and Hardware Requirements, page 2-2

• Checking Hardware and Software Compatibility, page 2-3

• Safety Guidelines, page 2-3

• Laser/LED Safety, page 2-8

Required Tools and Equipment

You need the following tools and parts to install a PA-FE-TX or PA-FE-FX port adapter. If you need

additional equipment, contact a service representative for ordering information.

• PA-FE-TX(=) or PA-FE-FX(=) port adapter

• Catalyst RSM/VIP2: For information about the specific VIP models that support the PA-FE-TX and

PA-FE-FX, see the “Minimum Software and Hardware Requirements” section on page 2-2.

• VIP: For information about the specific VIP models that support the PA-FE-TX and PA-FE-FX, see

the “Minimum Software and Hardware Requirements” section on page 2-2.

• RJ-45 and multimode optical fiber cables

• Number 1 Phillips and a 3/16-inch flat-blade screwdriver

• Number 2 Phillips screwdriver

• Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist

strap included with all upgrade kits, field-replaceable units (FRUs), and spares

• Antistatic mat

• Antistatic container

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 83 84

Pas de commentaire

Cisco Fourth-Generation Versatile Interface Processor VIP4 Spécifications Page 39