Cisco ATM Cable Interface Processor ACIP-SM(=) Spécifications télécharger pdf (Page 28)

28 ATM Cable Interface Processor (ACIP) Installation and Conﬁguration

Examples of ATM Error Messages

• To display ATM events, use the debug atm events command:

This command displays event changes to the ACIP. Reset, VC conﬁgurations, ACIP

conﬁgurations, and PLIM failures are displayed.

After you use a debug command, turn off debugging with the no debug command.

Following are additional debug commands speciﬁcally related to the ACIP:

• To display changes in connectivity to the TeraLink system, use the debug cable channel

command.

• To display changes in subscriber modem status, use the debug cable modem command.

• To display error messages that are caused by unexpected system behavior or problems

connecting to the Teralink system, use the debug cable error command.

Examples of ATM Error Messages

Following is a list of possible error messages displayed when you enter the debug atm event

command:

Error Message

RESET(ATM2/0): PLIM type is 0, Rate is 0Mbps

Explanation

Displays the PLIM TYPE value returned from the ACIP and the expected associated

rate.

Error Message

AIP_disable(ATM2/0): state=1

Explanation The DISABLE code to shut the ACIP down has been entered.

Error Message

conﬁg(ATM2/0)

Explanation The current conﬁguration to the ACIP was sent including TXBUFF, RXBUFF,

exception queue length, raw queue length, and rate queue information.

Error Message

AIP_enable(ATM2/0)

Explanation The ACIP is taken out of shutdown.

1 2 ... 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Cisco ATM Cable Interface Processor ACIP-SM(=) Spécifications Page 28