Cisco WS-X6416-GE-MT - Interface Module - Expansion Manuel d'utilisateur télécharger pdf (Page 49)

White Paper

Step 6. Configure trunk switchports: port 2/6 is used to carry all three VLANs to Cisco Catalyst B,

a Layer 2 Cisco Catalyst 6500. The trunk uses IEEE 802.1q encapsulation and defaults to

VLAN 1.

Cisco Catalyst OS Cisco IOS Software

set trunk 2/6 dot1q

set trunk 2/6 desirable

interface fastethernet 2/6

switchport

switchport mode dynamic desirable

switchport trunk encapsulation dot1q

Step 7. Optional configuration: By default, the Cisco Catalyst 6500 switch allows all VLANs on

the trunk. Configure the list VLAN 50-100 to be pruned from trunk.

Cisco Catalyst OS Cisco IOS Software

clear trunk 2/6 50-100 switchport trunk allowed vlan remove 50-100

Step 8. Configure the routed SVI: Step 4 configured the Gigabit Ethernet interfaces as routed

uplinks. This step shows the configuration for two SVI interfaces which provide routing

services for both VLANs (inter-VLAN routing). This configuration uses HSRP on VLAN 2

and 3 and also includes IPX network numbers.

Cisco Catalyst OS Cisco IOS Software

Routing is done on MSFC:

interface vlan2

ip address 10.10.2.2 255.255.255.0

standby 1 timers 1 3

standby 1 priority 200 preempt

standby 1 ip 10.10.2.6

ipx network 20

interface vlan3

ip address 10.10.3.2 255.255.255.0

standby 1 timers 1 3

standby 1 priority 200 preempt

standby 1 ip 10.10.3.6

ipx network 30

The Logical SVI interfaces are exactly the same as on MSFC.

The configuration on the left can be copied.

1 2 ... 44 45 46 47 48 49 50 51

Pas de commentaire

Cisco WS-X6416-GE-MT - Interface Module - Expansion Manuel d'utilisateur Page 49