Cisco WS-X6381-IDS - Intrusion Detection System Module Manuel d'utilisateur télécharger pdf (Page 6)

10-6 Cisco Secure Intrusion Detection System 2.1Lab 10.9.1 Copyright  2001, Cisco Systems, Inc.

Sensor’s host id 6

Sensor’s organization id P (where P = pod number)

Sensor’s organization name podP (where P = pod number)

Sensor’s IP address 10.0.P.6 (where P = pod number)

Policy Enforcement Associated

Network Service

Keep the default setting of Cisco Post

Office

Step 5 Click Next to continue. The Sensor Configuration window opens.

Step 6 Choose the Sensor Version and Signature Template to apply to the IDSM.

Your instructor will provide you with the values to complete the following table.

Parameter Value

Sensor version

Signature template

Step 7 Click Next to continue. The Ready to Proceed window opens.

Step 8 Verify the PostOffice parameters. Click Finish to add the IDSM to the network

topology.

Step 9 Click Update on the toolbar to save your changes and update the configuration

files.

Step 10 Select idsmP (where P = pod number) from the Network Topology Tree.

Step 11 Select the Command tab in the Sensor view panel.

Step 12 Click the Approve Now button in the Command Approval section. Wait for the

configuration files to be downloaded to the Sensor.

Step 13 After you get an Upload completed message in the Status section proceed to the

next task.

Note Notify the instructor that you have completed these tasks before proceeding.

Task 5—Apply a Signature Update

Perform the following lab steps to apply a signature update to the IDSM

application partition:

Step 1 Telnet into the switch from your Windows host.

Step 2 Session into your IDSM.

switch> session M

(where M = module number assigned)

Password: attack

Step 3 Go into configuration mode.

idsm# config t

1 2 3 4 5 6 7 8

Pas de commentaire

Cisco WS-X6381-IDS - Intrusion Detection System Module Manuel d'utilisateur Page 6