Cisco Wide Area Virtualization Engine 274 Guide de dépannage Page 100

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 594
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 99
1-14
Cisco Wide Area Application Services Configuration Guide
OL-26579-01
Chapter 1 Configuring AppNav
Configuring an AppNav Cluster
The following sections describe the interface configurations used by each of the four predefined
deployment models.
Single AppNav Controller WCCP Interception
With a 12-port AppNav Controller Interface Module:
Port channel 1—Contains ports GigabitEthernet 1/10 and 1/11
Cluster interface—Port channel 1
With a 4-port AppNav Controller Interface Module:
Cluster interface—GigabitEthernet 1/3
Dual AppNav Controllers WCCP Interception
With a 12-port AppNav Controller Interface Module:
Port channel 1—Contains ports GigabitEthernet 1/10 and 1/11
Port channel 2—Contains ports GigabitEthernet 1/8 and 1/9
Standby group 1—Contains interfaces Port channel 1 (primary) and Port channel 2
Cluster interface—Standby Group 1
With a 4-port AppNav Controller Interface Module:
Standby group 1—Contains ports GigabitEthernet 1/2 and 1/3 (primary)
Cluster interface—Standby Group 1
Single AppNav Controller Inline Interception
Interception bridge 1—Contains ports GigabitEthernet 1/0 (LAN) and 1/1 (WAN)
Cluster interface—GigabitEthernet 1/11
Dual AppNav Controllers Inline Interception
Interception bridge 1—Contains ports GigabitEthernet 1/0 (LAN) and 1/1 (WAN)
Interception bridge 2—Contains ports GigabitEthernet 1/2 (LAN) and 1/3 (WAN)
Standby group 1—Contains ports GigabitEthernet 1/10 and 1/11 (primary)
Cluster interface—Standby Group 1
Creating a New AppNav Cluster with the Wizard
Prerequisites
Set up the individual ANC and WN devices as described in the “Configuring WAAS Device
Interfaces” section on page 1-11.
Ensure that all ANCs are configured for AppNav Controller device mode. If you need to change the
device mode, see the “Changing Device Mode” section on page 1-16.
Use the Central Manager to configure basic settings for all devices such as NTP server, AAA,
logging, and so on.
Vue de la page 99
1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 593 594

Commentaires sur ces manuels

Pas de commentaire