Cisco SFE2000P - Managed Ethernet Switch Spécifications télécharger pdf (Page 9)

Chapter 2: Getting to Know the Switch

The Front Panel

Linksys One Ready Communications Solution

Chapter

Stack ID LEDs

Reset Switch

The Ethernet switch can be reset by inserting a pin or paper clip into the RESET opening. If

the reset switch is held for 10 seconds or longer, the Ethernet switch will be reset to its default

settings.

When a unit is reset to its default setting, the unit restarts in stackable mode using default

stacking ports with autonumbering enabled. Pressing the reset button on the master unit of a

stack resets all units in the stack.

LAN Ports

The Ethernet switch is equipped with 24 Ethernet ports.

Stack ID A green Stack ID LED indicates that this Switch is stacked and the

corresponding number indicates its stack ID. Range is 1 to 8.

CAUTION: All user-defined settings are

lost when you hold the Reset button for

10 seconds or longer; the Ethernet

switch reverts to its default settings.

1-24 The Switch is equipped with 24 auto-sensing, Ethernet (IEEE 802.3)

network ports, which use RJ-45 connectors. The Fast Ethernet ports

support network speeds of 10Mbps or 100Mbps. They can operate in

half and full-duplex modes. Auto-sensing technology enables each

port to automatically detect the speed of the device connected to it,

and adjust its speed and duplex accordingly.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 49 50

Pas de commentaire

Cisco SFE2000P - Managed Ethernet Switch Spécifications Page 9