Cisco SCE 1000 and Informations techniques télécharger pdf (Page 41)

Connect the Management Interface

Figure 13: Cabling the Management Port

Note

By default, the management port is configured to auto-negotiation enabled.

The SCE 1000 has two management ports, labeled Mng1 and Mng 2. Use the Mng 1 port.

Step 1 Plug the Ethernet cable provided (with attached RJ-45 connector) into the Mng 1 port on the front panel of the

SCE 1000.

Step 2 Connect the other end of the Ethernet cable into your management network.

The Link LED on the SCE 1000 management port should light up.

Step 3

Test connectivity. From the host that you intend to use for remote management, ping to the SCE 1000 by typing

ping and the SCE 1000 IP address, and pressing Enter (see the example, below).

This verifies that an active connection exists between the specified station and the management port.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 57 58

Pas de commentaire

Cisco SCE 1000 and Informations techniques Page 41