Cisco PIX-515E Guide d'installation télécharger pdf (Page 4)

4-4

Cisco PIX Firewall Hardware Installation Guide

78-13880-01

Chapter 4 PIX 515/515E

Installing a PIX 515/515E

PIX 515/515E Surface Mounting

If you do not want to rack mount the unit, attach the rubber feet to the bottom of the unit as shown in

Figure 4-5.

Figure 4-5 Attaching the Rubber Feet to the PIX 515/515E

PIX 515/515E Rack Mounting

Observe the following before installing the PIX 515/515E into an equipment rack:

• To install optional circuit boards or memory, install the brackets on the unit for rack mounting, but

do not put the PIX 515/515E in the equipment rack before installing the new boards. The chassis

cover of the PIX 515/515E must be removed to properly install or remove a circuit board. Refer to

“Removing and Replacing a PIX 515/515E Chassis Cover” for information on how to remove and

replace the chassis cover.

–

If you need information on installing a circuit board, refer to “Installing a Circuit Board in a

PIX 515/515E”.

–

If you need to install additional memory, refer to “Installing a Memory Upgrade”.

Complete these steps to install the PIX 515/515E in a rack:

Step 1 Attach the bracket to the unit using the supplied screws. You can attach the brackets to the holes near

the front of the unit.

Step 2 Attach the unit to the equipment rack.

Fan

Unused

24301

1 2 3 4 5 6 7 8 9 ... 19 20

Pas de commentaire

Cisco PIX-515E Guide d'installation Page 4