Cisco Network Convergence System 6000 Series Guide d'installation télécharger pdf (Page 3)

5-3

Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide

Chapter 5 Installing Route Processor Cards, Line Cards, and Fabric Cards

About Installing Cards and Associated Components

Caution The chassis may indicate a hardware failure if you do not follow proper procedures. Remove or install

only one card at a time. Allow at least 15 seconds for the chassis to complete its tasks before removing

or installing another card.

Steps for OIR Fabric Card Removal

Follow these steps to perform a graceful OIR on the fabric card by using the Cisco IOS XR shutdown

command.

Step 1 Shut down plane X (where X is in the range of 0 to 5).

config

controller fabric plane X

shutdown

commit

Step 2 Shut down FC card location R/FCS (where R is the rack number in the range of 0 to 15 and F0 to F3, and

S is the slot in the range of 0 to 5 for the LCC and 0 to 11 for the FCC).

config

hw-module location R/S shutdown

commit

…

Step 3 Unshut FC location.

config

no hw-module location R/S shutdown

commit

Step 4 Unshut plane X.

config

controller fabric plane X

no shutdown

commit

1 2 3 4 5 6 7 8 ... 35 36

Pas de commentaire

Cisco Network Convergence System 6000 Series Guide d'installation Page 3