Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Fiche technique télécharger pdf (Page 162)

642 -531

Leading the way in IT testing and certification tools, www.testking.com

- 162 -

QUESTION NO: 5

What command could you use on your PIX Firewall to view the current names and

security levels for each interface?

A. Show ifconfig

B. Show nameif

C. Show all

D. Ifconfig /all

Answer: B

Explanation:

Use the show nameif command to determine which interface is being described in a message

containing this variable.

Reference: Cisco PIX Firewall Software Introduction

QUESTION NO: 6

Which of the following commands let you view, change, enable, or disable the use of a

service or protocol through the PIX Firewall?

A. fixing protocol

B. set firewall

C. fixup protocol

D. change –all fix

Answer: C

Explanation:

The fixup protocol commands let you view, change, enable, or disable the use of a service or

protocol through the PIX Firewall. The ports you specify are those that the PIX Firewall

listens at for each respective service.

Reference: Cisco PIX Firewall Command Reference, Version 6.3

Note: In Appendix B of the Cisco Secure Intrusion Detection System 4 Fixup protocol is not

talked about.

QUESTION NO: 7

Debugging a PIX is what you want to do to resolve a problem.

What command would you use to display the current state of tracing?

A. show debug

B. debug all

C. all on debug

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 168

Pas de commentaire

Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Fiche technique Page 162