Cisco DPC 3925 Guide de l'utilisateur Page 60
- Page / 106
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
60 4021192 Rev B
Configure Security
Section
Field Description
Key
Management
(continued)
Select one of the following options for the key exchange method:
Auto (IKE)
– Encryption: The Encryption method determines the length of the key used
to encrypt/decrypt ESP packets. Notice that both sides must use the same
method.
– Authentication: The Authentication method authenticates the
Encapsulating Security Payload (ESP) packets. Select MD5 or SHA. Notice
that both sides (VPN endpoints) must use the same method.
MD5: A one-way hashing algorithm that produces a 128-bit digest
SHA: A one-way hashing algorithm that produces a 160-bit digest
– Perfect Forward Secrecy (PFS): If PFS is enabled, IKE Phase 2 negotiation
will generate new key material for IP traffic encryption and authentication.
Note that both sides must have PFS enabled.
– Pre-Shared Key: IKE uses the Pre-Shared Key to authenticate the remote
IKE peer. Both character and hexadecimal values are acceptable in this
field, e.g., "My_@123" or "0x4d795f40313233". Note that both sides must use
the same Pre-Shared Key.
– Key Lifetime: This field specifies the lifetime of the IKE generated key. If
the time expires, a new key will be renegotiated automatically. The Key
Lifetime may range from 300 to 100,000,000 seconds. The default lifetime is
3600 seconds.
Manual
– Encryption: The Encryption method determines the length of the key used
to encrypt/decrypt ESP packets. Notice that both sides must use the same
method.
– Encryption Key: This field specifies a key used to encrypt and decrypt IP
traffic. Both character and hexadecimal values are acceptable in this field.
Note that both sides must use the same Encryption Key.
– Authentication: The Authentication method authenticates the
Encapsulating Security Payload (ESP) packets. Select MD5 or SHA. Notice
that both sides (VPN endpoints) must use the same method.
MD5: A one-way hashing algorithm that produces a 128-bit digest
SHA: A one-way hashing algorithm that produces a 160-bit digest
– Authentication Key: This field specifies a key used to authenticate IP
traffic. Both character and hexadecimal values are acceptable in this field.
Note that both sides must use the same Authentication Key.
– Inbound SPI/Outbound SPI: The Security Parameter Index (SPI) is carried
in the ESP header. This enables the receiver to select the SA, under which a
packet should be processed. The SPI is a 32-bit value. Both decimal and
hexadecimal values are acceptable. e.g., "987654321" or "0x3ade68b1". Each
tunnel must have a unique Inbound SPI and Outbound SPI. No two tunnels
share the same SPI. Note that the Inbound SPI must match the remote
gateway's Outbound SPI, and vice versa.
- 8x4 DOCSIS 3.0 Wireless 1
- Notice to Installers 2
- 20080814_Installer820_Intl 3
- Power Source Warning 4
- Ground the Product 4
- Check Product Safety 6
- Telephone Equipment Notice 6
- Declaration of Conformity 7
- Canada EMI Regulation 7
- Australia 8
- CE Compliance 9
- National Restrictions 10
- Antennas 11
- Introduction 12
- Introduction 13
- What's In the Carton? 14
- Front Panel Description 15
- Back Panel Description 16
- 4021192 Rev B 17 17
- 18 4021192 Rev B 18
- Service? 19
- 20 4021192 Rev B 20
- Gateway? 21
- Before You Begin 22
- 4021192 Rev B 23 23
- 24 4021192 Rev B 24
- Number of Telephone Devices 25
- Telephone Device Types 25
- Dialing Requirements 25
- 4021192 Rev B 27 27
- 28 4021192 Rev B 28
- 4021192 Rev B 29 29
- 30 4021192 Rev B 30
- Setup > Quick Setup 31
- Configuring Quick Settings 32
- Enable 33
- Disable 33
- Setup > Lan Setup 34
- 4021192 Rev B 35 35
- Setup > DDNS 36
- User Name 37
- Password 37
- Host Name 37
- Configure Wireless Settings 38
- 4021192 Rev B 39 39
- 40 4021192 Rev B 40
- 4021192 Rev B 41 41
- 42 4021192 Rev B 42
- 4021192 Rev B 43 43
- 44 4021192 Rev B 44
- 4021192 Rev B 45 45
- Wireless > MAC Filter 46
- 4021192 Rev B 47 47
- 4021192 Rev B 49 49
- 50 4021192 Rev B 50
- Wireless > WDS Settings 51
- Wireless > QoS 52
- Disable (factory default) 53
- Configure Security 54
- 4021192 Rev B 55 55
- Enable (factory default) 56
- Security > VPN 57
- 58 4021192 Rev B 58
- 4021192 Rev B 59 59
- Auto (IKE) 60
- Manual 60
- Phase 1 - Operation Mode 61
- Local Identity 61
- Remote Identity 61
- Encryption 61
- 4021192 Rev B 63 63
- 64 4021192 Rev B 64
- 4021192 Rev B 65 65
- 66 4021192 Rev B 66
- 4021192 Rev B 67 67
- 68 4021192 Rev B 68
- 4021192 Rev B 69 69
- 70 4021192 Rev B 70
- 4021192 Rev B 71 71
- Overview 72
- Both 73
- 4021192 Rev B 75 75
- Manage the Gateway 78
- 4021192 Rev B 79 79
- 80 4021192 Rev B 80
- 4021192 Rev B 81 81
- 82 4021192 Rev B 82
- View Log 83
- 84 4021192 Rev B 84
- 4021192 Rev B 85 85
- Restore Factory Defaults 86
- Monitor Gateway Status 87
- Status > Local Network 88
- 4021192 Rev B 89 89
- Status > Wireless 90
- 2.4 GHz 91
- 5 GHz 91
- 2.4 and 5 GHz 91
- Status > DOCSIS WAN 92
- 4021192 Rev B 93 93
- Frequently Asked Questions 94
- Frequently Asked Questions 95
- Check and Correct 98
- 4021192 Rev B 101
- Front Panel Indicator 101
- Normal Operations 101
- Special Conditions 102
- Notices 103
- For Information 105
Produits connexes et manuels pour Mise en réseau Cisco DPC 3925
(126 pages)
(73 pages)
(15 pages)
Mise en réseau Cisco uBR904 Spécifications
(38 pages)
(38 pages)
Mise en réseau Cisco NSLU2 Fiche technique
(14 pages)
(14 pages)
(50 pages)BORK SF NNN 3340 SI manuals
Owner’s manuals and user’s guides for Fans BORK SF NNN 3340 SI.
We providing 1 pdf manuals BORK SF NNN 3340 SI for download free by document types: User Manual
Commentaires sur ces manuels