Cisco CX-FEIP-2TX= Installation and con?guration Guide de l'utilisateur télécharger pdf (Page 25)

Fast Ethernet Interface Processor (FEIP) Installation and Configuration 25

Attaching Fast Ethernet Interface Cables

Figure 19 Connecting MII or SC Cables (FEIP-2FX Shown, Horizontal Orientation)

Step 2

For the 100BASE-TX RJ-45 connections, attach the ferrite bead to the RJ-45 cable (at

either end), as shown in Figure 20.

Caution The ferrite bead prevents electromagnetic interference (EMI) from affecting the

100BASE-TX-equipped system and is a required component for proper system operation.

Figure 20 Attaching the Ferrite Bead around the RJ-45 Cable

Caution

To prevent problems on your FEIP and network, do not simultaneously connect RJ-45 (or SC) and

MII cables to one port adapter. On a single port adapter, only one network connection can be used at one time.

Only connect cables that comply with EIA/TIA-568 standards. (Refer to Table 1 and Table 2, on page 9, for

cable recommendations and speciﬁcations.)

Step 3 Attach the network end of your RJ-45 (or SC) or MII cable to your 100BASE-T

transceiver, switch, hub, repeater, DTE, or other external 100BASE-T equipment.

Step 4 Repeat Steps 1 through 3 for the second port adapter as required.

This completes the FEIP cable installation.

H9785

MII cable

To transceiver,

repeater, or DTE

FAST ETHERNET

FIBER

LINK

MII

Simplex (2)

To repeater

Duplex (1)

To repeater

FAST ETHERNET

FIBER

LINK

MII

H4202

Ferrite bead RJ-45 cable

with ferrite bead

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 39 40

Pas de commentaire

Cisco CX-FEIP-2TX= Installation and con?guration Guide de l'utilisateur Page 25