Cisco CTX2500 Informations techniques télécharger pdf (Page 23)

Input Example:

OPR-LPBK-DS1:PTREYES:DS1-4-1-2-13:203::NEND,,,FACILITY;

RLS-LPBK-T1

Use the RLS-LPBK-T1 command to release a loopback. The RLS-LPBK-T1 command is listed as

RLS-LPBK-<MOD2> in the Cisco ONS SONET TL1 Command Guide. T1 is just one of the options

you can enter. RLS-LPBK-T1 is from the Troubleshooting and Test Access category.

Input Format:

RLS-LPBK-<MOD2>:[<TID>]:<SRC>:<CTAG>::[<LOCATION>],,,[<LPBKTYPE>];

• TID is the name of the node you want to access. If you only want to query the node you connected

to leave the TID blank.

• SRC is an access identifier. Valid values are facility, DS1, and STS.

• CTAG is any non-blank character series that does not have to be unique.

• LOCATION is the location where the operation is to be carried out.

• LPBKTYPE is a loopback type and is optional. LPBKTYPE can be FACILITY or TERMINAL.

Input Example:

RLS-LPBK-DS1:PTREYES:DS1-4-1-2-13:203::NEND,,,FACILITY;

7 Log Out of TL1

When you are finished using TL1, you must log out of the session. Logging out of TL1 only has to be

done once per session.

Step 1 If you logged into TL1 via CTC, you must log out by pressing the Disconnect button or by

issuing the CANC-USER command as shown in the following steps.

If you logged into TL1 via Telnet or craft interface, you must log out by issuing the

CANC-USER command.

Input Format:

CANC-USER:[<TID>]:<USERID>:<CTAG>;

• TID is the name of the node you want to access. If you only want to query the node you

connected to leave the TID blank.

• USERID is your user ID. Maximum of 10 alphanumeric characters.

• CTAG is any non-blank character series that does not have to be unique.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30

Pas de commentaire

Cisco CTX2500 Informations techniques Page 23