Cisco Aironet 340 Series Informations techniques télécharger pdf (Page 7)

Select the letter for the firmware file that displays. This message appears while the AP starts the

firmware:

Inflating firmware file name

When the Express Setup screen appears, begin to reconfigure the AP with the terminal emulator or an

Internet browser.

10.

Reset the APVxWorks Version 11.07 or Later

Complete these steps in order to reset the AP on versions 11.07 and later:

Connect to the AP.1.

When the Summary Status screen appears, reboot the AP.

In order to reboot, you can unplug and then replug the power connector or press CTRL−X.

Here is an example of the Summary Status screen:

When the AP reboots and the Summary Status screen reappears, issue the :resetall command.

Note: If you do not allow users to browse in a read−only manner without the need to log in, you do

not see the Summary Status screen. Instead, you are prompted for a username and password. Enter

any username and password. You then see this prompt:

Authentication Failed − Retry? (y/n)

Note: Answer n to the question. You are now able to issue the :resetall command. In order to allow

or not allow users to browse in a read−only manner, use the User Manager Setup:

Cisco − Password Recovery Procedure for the Cisco Aironet Equipment

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Pas de commentaire

Cisco Aironet 340 Series Informations techniques Page 7