Cisco AG310 Guide de l'utilisateur télécharger pdf (Page 54)

Chapter 6: Configuring the ADSL2+ Gateway

The Administration - Factory Defaults Tab

ADSL2+ Gateway with VoIP

The Administration - Factory Defaults Tab

Factory Defaults

Restore Factory Defaults. If you wish to restore the Gateway to its factory default settings and lose all your

settings, click Yes.

To begin the restore process, click the Save Settings button to save these changes, or click the Cancel

Changes button to undo your changes.

The Administration - Firmware Upgrade Tab

The Gateway allows you to upgrade firmware from the LAN (Local Area Network) side of the Gateway.

Upgrade from LAN

To upgrade the Gateway’s firmware from the LAN:

1. Download the Gateway’s firmware upgrade file from www.linksys.com.

2. Extract the file on your computer.

3. Click the Browse button to find the firmware upgrade file.

4. Double-click the firmware file that you have downloaded and extracted.

5. Click the Upgrade button, and follow the on-screen instructions.

To cancel the firmware upgrade, click the Cancel Upgrade button.

Figure 6-44: Firmware Upgrade

Figure 6-43: Factory Defaults

IMPORTANT: Do not turn off the power or press the reset button while the upgrade is in

process.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 86 87

Pas de commentaire

Cisco AG310 Guide de l'utilisateur Page 54