Cisco E2500 Manuel d'utilisateur télécharger pdf (Page 4)

Linksys® E2500 Wireless-N Router Configuration Guide

1 Introduction

Thank you for purchasing the Maretron preconfigured Linksys

E2500 Wireless-N Router (from

here on referred to as WiFi/Router). The WiFi/Router is used to interconnect one or more wired

or wireless devices running Maretron’s N2KView

vessel monitoring and control software with

a device running Maretron’s N2KServer

(i.e., N2KServer

runs on Maretron’s Internet

Protocol Gateway (IPG100) or a PC connected to an NMEA 2000

network via Maretron’s

USB gateway (USB100)). Figure 1 shows a typical configuration where multiple devices

running Maretron’s N2KView

software (e.g., laptop computer, desktop computer, smart

phone, tablet, Maretron DSM800 display, or Maretron MBB100 black box) are connected back

to an NMEA 2000

network through the WiFi/Router and the Maretron Internet Protocol

Gateway (IPG100).

Figure 1 - Typical WiFi/Router Connection

Although the WiFi/Router is mostly pre-configured by Maretron, there are a few steps that must

be performed to establish the connection between Maretron’s N2KView

vessel monitoring

Page 4 Revision 1.0

1 2 3 4 5 6 7 8 9 ... 26 27

Pas de commentaire

Cisco E2500 Manuel d'utilisateur Page 4