Cisco 8 - Route Switch Processor 8 Spécifications télécharger pdf (Page 49)

Route Switch Processor (RSP8) Installation and Configuration Guide

OL-4920-02

Enabling High Availability Features

controller T3 6/0/0

clock source line

interface Ethernet0/0/0

ip address 10.0.0.1 255.255.0.0

no ip directed-broadcast

ip route-cache distributed

no keepalive

exec-timeout 0 0

history size 40

transport preferred none

transport input none

line aux 0

line vty 0 4

Configuring a Stateful Switchover (SSO)

To configure SSO, use the following commands beginning in privileged EXEC configuration mode:

Command Purpose

Step 1

Router# configure terminal Enters global configuration mode.

Step 2

Router(config)# hw-module slot slot-number image file-spec Specifies the image to be used by the active RSP at

initialization. If a high-availability image is found,

the running configuration is updated.

• slot-number—Specifies the active RSP slot

where the Flash memory card or Flash Disk is

located. Valid numbers are slot 2 or slot 3 for

a Cisco 7507 router or slot 6 or slot 7 for a

Cisco 7513 router.

• file-spec—Indicates the Flash device and the

name of the image on the active RSP.

Note Step 2 and Step 3 are the same; Step 2

applies to the active RSP and Step 3

applies to the standby RSP.

Note The image indicated by the file-spec

attribute must be available on the local

Flash device. Remote protocols such a

TFTP and remote copy are not available.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 91 92

Pas de commentaire

Cisco 8 - Route Switch Processor 8 Spécifications Page 49