Cisco 7609 Spécifications télécharger pdf (Page 34)

100

101

2-2

Cisco 7600 Series Router Cisco IOS Software Configuration Guide—12.1E

78-14064-04

Chapter 2 Command-Line Interfaces

Accessing the CLI

To make a console connection, perform this task:

After making a console connection, you see this display:

Press Return for Console prompt

Router> enable

Password:

Router#

Accessing the CLI through Telnet

Note Before you can make a Telnet connection to the router, you must configure an IP address (see the

“Configuring IP Routing and Addresses” section on page 12-2).

The router supports up to eight simultaneous Telnet sessions. Telnet sessions disconnect automatically

after remaining idle for the period specified with the exec-timeout command.

To make a Telnet connection to the router, perform this task:

Command Purpose

Step 1

Press Return. Brings up the prompt.

Step 2

Router> enable

Initiates enable mode enable.

Step 3

Password: password

Router#

Completes enable mode enable.

Step 4

Router# quit

Exits the session when finished.

Command Purpose

Step 1

telnet {hostname | ip_addr}

Makes a Telnet connection from the remote host, to the

router you want to access.

Step 2

Password: password

Router#

Initiates authentication.

Note If no password has been configured, press

Return.

Step 3

Router> enable

Initiates enable mode enable.

Step 4

Password: password

Router#

Completes enable mode enable.

Step 5

Router# quit

Exits the session when finished.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 571 572

Commentaires sur ces manuels

Pas de commentaire

Cisco 7609 Spécifications Page 34

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Cisco 7609