Cisco 4404 - Wireless LAN Controller Spécifications télécharger pdf (Page 24)

Installation and Configuration

Connecting and Using the CLI Console

Cisco 4400 Series Wireless LAN Controllers - Installation and Configuration Guide

78-17157-01

Connecting and Using the CLI Console

For initial system configuration, use the command-line interface (CLI) console. As shown in the

following figure, the CLI console connects to the controller front-panel console port.

Figure 4 CLI Console Connection to Controller

Do the following to connect the CLI console to the controller:

• Use a null-modem serial cable to connect the CLI console to the controller console port.

Note The Cisco Wireless LAN Controller end of the cable is female DB-9. The other end should be any kind

of connector that plugs into your VT-100 terminal emulator (usually a laptop or palmtop computer).

• Make sure the VT-100 terminal emulator (HyperTerminal, ProComm, minicom, tip, or other) is

configured for the following parameters:

–

9600 baud

–

8 data bits

–

no flow control

–

1 stop bit

–

no parity

142201

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 45 46

Pas de commentaire

Cisco 4404 - Wireless LAN Controller Spécifications Page 24