Cisco 2948G-GE-TX - Catalyst Gigabit Ethernet Switch Guide d'installation télécharger pdf (Page 6)

Chapter 4 Configuring the Gigabit Ethernet Ports

Installing, Removing, and Maintaining GBICs

4-6

Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide

78-6286-04

• You must insert a 5-dB inline optical attenuator between the single-mode

fiber-optic network and the receiving port on the 1000BASE-ZX GBIC at

each end of the link if the link is greater than 15.5 miles (25 km), but less than

31 miles (50 km).

Installing GBICs

This section describes how to install GBICs.

Caution Unnecessary removal and insertion of a GBIC could lead to premature failure of

the GBIC. A GBIC has a lifetime of 100 to 500 removals and insertions.

A switch can be shipped with or without GBICs installed.

Caution When removing or inserting a GBIC, always wear an ESD wrist strap connected

to the ESD wrist strap connector. For more information about ESD, refer to the

Site Preparation and Safety Guide.

Note GBICs are online swappable.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Pas de commentaire

Cisco 2948G-GE-TX - Catalyst Gigabit Ethernet Switch Guide d'installation Page 6