Cisco 1711 - Security Access Router Guide d'installation télécharger pdf (Page 11)

2-11

Cisco 1711 and Cisco 1712 Security Access Routers Hardware Installation Guide

OL-4050-02

Chapter 2 Installation

Optional Installation Steps

Connecting a PC to the Router’s Console Port

If you want to configure the router by using the Cisco IOS command-line

interface, you must connect the router console port to a terminal or PC. The cable

and adapter required for this connection are included with the router.

To configure the router by using a PC, the PC must have some type of terminal

emulation software installed. The software should be configured with the

following parameters:

• 9600 baud

• 8 data bits

• No parity bits

• 1 stop bit

Note Refer to the Cisco 1700 Router Software Configuration Guide for detailed

information about configuring the router using Cisco IOS software.

To connect the Cisco 1711 or Cisco 1712 Security Access router to a terminal or

PC, follow these steps:

Step 1 Connect the blue console cable to the blue console port on the back of the router,

as shown in Figure 2-5 on page 2-12.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Cisco 1711 - Security Access Router Guide d'installation Page 11