Cisco 11154 - CSS - Switch Spécifications télécharger pdf (Page 83)

3-5

Content Services Switch Getting Started Guide

78-11766-01

Chapter 3 Booting the CSS

Booting the CSS for the First Time

For example:

(config-boot)# shutdown

Once the CSS shuts down all processes, you may remove power from the CSS.

Booting the CSS for the First Time

When the CSS initially boots up, it:

• Performs hardware diagnostics.

• Validates the integrity of the disk file system automatically. If the CSS:

–

Does not detect errors, it reports a status of OK and continues the boot

process

–

Detects errors, it returns a status of DIRTY, runs a quick check disk

automatically, and continues the boot process

• Prompts you to:

–

Enter the software license key, located on a card in an envelope in the

Accessory kit

–

Configure the IP address and subnet mask for the Ethernet Management

port, used for CSS configuration and management only; this port does not

route traffic

–

Change the default administrative login name (admin) and password

(

system)

–

Password-protect the Offline Diagnostic Monitor menu (Offline DM

menu)

The initial boot-up prompts are described in the sections below.

Entering Your License Key

When the CSS completes hardware initialization and power-on diagnostics, you

must enter a valid license key for the CSS software. The CSS does not require you

to enter this key on subsequent startups.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 147 148

Pas de commentaire

Cisco 11154 - CSS - Switch Spécifications Page 83