Cisco BayTech DS Series Manuel d'utilisateur télécharger pdf (Page 4)

DS62-MD4 Network/Modem Host Module

Serial Setup

• Verify JMP5 is set to pins 1 and 2 on the

DS62 &

DS62-MD4 module.

• Connect the 9FRJ45PC-4 adapter to the user’s computer

• Connect the Host Module’s EIA-232 port to the adapter via the RJ08X007 rolled flat ribbon

cable.

• Use terminal emulation software to access the unit, 9600 bps, 8 data bits, 1stop bit and no

parity.

NOTE: At any time during the session you need to go to another menu, use the Attention

Character = semi-colon (;). Press the attention character key 5 consecutive times to get back to the

main status menu.

Figure 1

Select option ‘C’ for the configuration menu. Select the DS62 module option and the following menu

is displayed:

Module Name: DS62

Module: 1

Attention Character: ;

Device A (2 ,1).........1

Device B (2 ,2).........2

Device C (2 ,3).........3

Device D (2 ,4).........4

DS-DS (5 ,1).........5

Status..........................S Current configuration

Configure.......................C Make Changes

Unit Reset......................RU Resets the DS-Unit, terminates internal &

external modem connections, allow 10

seconds for reset.

Logout..........................T

Enter Request :c

1 2 3 4 5 6 7 8 9

Pas de commentaire

Cisco BayTech DS Series Manuel d'utilisateur Page 4