Cisco 7300-6T3 Manuel d'utilisateur télécharger pdf (Page 23)

CHAPTER

2-1

Clear Channel 6-Port T3 (DS3) Line Card Installation and Configuration

OL-3449-02

Preparing for Installation

This chapter describes the general equipment, safety, and site preparation requirements for installing the

6T3 line card. This chapter contains the following sections:

• Required Tools and Equipment, page 2-1

• Software and Hardware Requirements, page 2-2

• 75-Ohm In-Line Coaxial Attenuator (Optional), page 2-2

• Safety Guidelines, page 2-2

Required Tools and Equipment

You need the following tools and parts to install a line card. If you need additional equipment, contact

a service representative for ordering information.

• 6T3 line card

• T3 SMB interface cables

• Number 2 Phillips screwdriver

• Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist

strap included with all upgrade kits, field-replaceable units (FRUs), and spares

• Antistatic mat

• Antistatic container

• Attenuator kit (optional)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 53 54

Pas de commentaire

Cisco 7300-6T3 Manuel d'utilisateur Page 23