Cisco 3545 MCU Manuel d'utilisateur télécharger pdf (Page 22)

2-16

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Releases 5.6 adn 5.7

OL-17013-01

Chapter 2 Installing the Cisco Unified Videoconferencing 3545 MCU

Removing the MCU and EMP

Caution Do not force the connection. Forcing the connection can bend or damage the pins in the

connector inside the chassis.

Note If you are installing the MCU or the EMP module and the power to the chassis is on, the SWAP

RDY LED on the module front panel turns blue when you slide the module into the chassis as

far as it will go. This means that you can secure the module safely. The LED turns off when the

handles are closed.

Step 8 Snap the handles forward to secure the MCU or the EMP module in the slot.

Step 9 Secure the MCU or the EMP module screws.

Caution Blank faceplates and cover panels serve three important functions: they prevent exposure to

hazardous voltages and currents inside the chassis; they contain electromagnetic interference

(EMI) that might disrupt other equipment; and they direct the flow of cooling air through the

chassis. Do not operate the system unless all cards, faceplates, front covers and rear covers

are in place.

Removing the MCU and EMP

This section describes how to remove the MCU or the EMP from the Cisco Unified

Videoconferencing

3545 chassis.

Procedure

Step 1 Loosen the MCU or the EMP module screws.

Step 2 Press the red buttons and open the handles of the MCU or the EMP module (see Figure 2-5).

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

Pas de commentaire

Cisco 3545 MCU Manuel d'utilisateur Page 22