Cisco ASA5555-CU-2AC-K9 Guide d'installation télécharger pdf (Page 69)

4-19

Cisco ASA 5500-X Series Hardware Installation Guide

OL-32129-01

Chapter 4 Maintenance and Upgrade Procedures for the ASA 5500-X

Remove and Install the Power Supply

Figure 4-23 Color-coded Wires

Figure 4-24 shows the DC power supply with lead wires.

Figure 4-24 DC Power Supply with Lead Wires

Step 7

Insert the exposed end of one of the ground wires into the inlet on the DC power supply. After you push

in the wires, they are held in place with a spring, which makes the physical contact. Make sure that you

cannot see any wire lead. Only wires with insulation should extend from the DC power supply.

Step 8 Repeat Step 7 for the remaining two DC input power source wires: the positive lead wire and the negative

lead wire.

1 Negative (–) lead wire 2 Ground lead wire

3 Positive (+) lead wire

333057

333060

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 75 76

Pas de commentaire

Cisco ASA5555-CU-2AC-K9 Guide d'installation Page 69