Cisco SFS 7008 Manuel d'utilisateur télécharger pdf (Page 97)

Run a Self-Test on a Power Supply

1. Show the ID of the power supply that you want to diagnose, if you do not already know the

number.

a. Enter the show power-supply command.

Example

2. Enter the diag power-supply <id> command and specify the type of test (self-test is chosen by

default).

Example

3. Start the test.

Example

4. Use the show diag fan command to show the progress of the test.

Example

Topspin-270# show power-supply

=====================================================================

Power-supply Information

=====================================================================

ps type admin-status oper-status utilization voltage

---------------------------------------------------------------------

1 AC up up n/a 48

2 AC up up 15 47

Topspin-270> enable

Topspin-270# config

Topspin-270(config)# diag power-supply 2

Topspin-270(config-diag-power-supply-2)# test self-test

Topspin-270(config-diag-power-supply-2)# start

Topspin-270(config-diag-power-supply-2)# exit

Topspin-270(config)# exit

Topspin-270# show diag power-supply

================================================================================

Diagnostic Tests For Power Supply

================================================================================

module-type : power-supply

module-number : 2

test : self-test

iterations : 1

action : start

result : success

percentage-completed : 100

result-string : Self Test, Final report : PASSED; Please reboot syst

Topspin-270#

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 107 108

Pas de commentaire

Cisco SFS 7008 Manuel d'utilisateur Page 97