Cisco DVR Guide d'installation télécharger pdf (Page 10)

Connecting to the In-Home Network

The following diagrams illustrate examples of the connections you can use to connect

your set-top to your in-home network. Contact your service provider for the recommended

connection method for your home.

Note: The illustrations below may vary from the actual product.

CableCARD

SATA Drive Ethernet

1394

Firewire

CATV Converter

Made in Mexico

This device is intended to be attached to

a receiver that is not used to receive

over-the-air broadcast signals.

Connections of thisdevice in any other

fashion may cause harmful interference

to radio communications and is in

violation of the FCC rules, part 15.

FIOS TV In

STB SN: XXXXXXXXX

STB RF MAC: XXXXXXXXXXXX

T14395

Coaxial

In-Home

Coaxial

Network

Wall

Ethernet

In-Home

CAT-5

Network

Wall

WARNING: The Ethernet port of this equipment is suitable for connection to

intra-building or unexposed wiring or cabling only. The Ethernet port of this

equipment MUST NOT be metallically connected to interfaces that connect to

the OSP (OutSide Plant) or its wiring. The Ethernet port is designed for use as

an intra-building interface only (Type 2 or Type 4 ports as described in GR-1089-

CORE, Issue 4) and requires isolation from the exposed OSP cabling. The addition

of Primary Protectors is not sufﬁ cient protection in order to connect these

interfaces metallically to OSP wiring.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Pas de commentaire

Cisco DVR Guide d'installation Page 10