Quick Start GuideINSTALLING YOUR CISCO 1605 ROUTERUNPACK THE BOX.INSTALL THE ROUTER.VERIFY YOUR INSTALLATION.Cisco 1605HubHubPCPCPCPCPCInternetEtherne
2Note: The Cisco 1600 series routers are either of run-from-flash (RFF) or run-from-RAM (RFR) models. Inthis document, model names without an R refer t
3There are three steps to installing your router:Install the Router.Warning Hazardous network voltages are present in WAN interface card ports regardl
4A. Connect the router to the local networks.The router has three Ethernet ports, but supports only two Ethernet connections at one time. Connect the
5B. Install the WAN interface card.Look for a WAN interface card in the slot on the right-rear of the router, just above the slot labeled FLASH PCCARD
6C. Connect the power supply.Install the Router (continued).After connecting the router to power and turning it on, you can confirm that you have insta
7Verify Your Installation.After the router is powered on, the following LEDs confirm that you have correctly installed your router.For More Information
Corporate HeadquartersCisco Systems, Inc.170 West Tasman DriveSan Jose, CA 95134-1706USAhttp://www.cisco.comTel: 408 526-4000800 553-NETS (6387)Fax: 4
Commentaires sur ces manuels