Cisco Catalyst 2960-48PST Guide d'installation télécharger pdf (Page 53)

2-21

Catalyst 2960 Switch Hardware Installation Guide

OL-7075-09

Chapter 2 Switch Installation (24- and 48-Port Switches)

Where to Go Next

Figure 2-19 Connecting to a Dual-Purpose Port

Step 2

Connect the other end of the cable to the other device. The switch automatically detects the connection

and configures the port.

By default, the switch automatically selects the interface type the first time a port links up. For

subsequent links, you must use the media-type interface configuration command to manually configure

either the RJ-45 connector or the SFP module connector. For more information, see the command

reference.

Where to Go Next

If the default configuration is satisfactory, the switch does not need further configuration. You can use

any of these management options to change the default configuration:

•

Start the device manager, which is in the switch memory, to manage individual switches. The device

manager is an easy-to-use web interface that offers quick configuration and monitoring. You can

access the device manager from anywhere in your network through a web browser. For more

information, see the device manager online help.

•

Start the Network Assistant application, which is described in the Getting Started with Cisco

Network Assistant guide. Through this GUI, you can configure and monitor a switch cluster or an

individual switch.

•

Use the CLI from the console to configure the switch as a member of a cluster or as an individual

switch. See the Catalyst 2960 Switch Software Configuration Guide and the Catalyst 2960 Switch

Command Reference on Cisco.com for information on using the CLI with a Catalyst 2960 switch.

•

Start an SNMP application such as the CiscoView application.

1 RJ-45 connector 2 LC connector

204635

Catalyst 2960

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 107 108

Pas de commentaire

Cisco Catalyst 2960-48PST Guide d'installation Page 53