Cisco MEM800-8U12D Fiche technique télécharger pdf (Page 14)

Release Notes for Cisco IOS Release 12.0(7)XV Feature Packs for the Cisco 800 Series

78-10446-01

Installation Notes

Step 1 Install any TFTP server application on the PC. (A PC application is included on the feature pack

CD-ROM for Microsoft Windows 95 only.)

Step 2 Start the TFTP server application on the PC by double-clicking the application icon or its .exe

filename.

Step 3 Set up the PC as a TFTP server by using the TFTP server application setup or configuration facility.

Most TFTP server applications include a setup facility that allows you to specify the PC as a server. For

example, from the TFTP menu of one application, select Settings to display a panel. To configure the

local PC as a server, select the Server checkbox.

Select a root directory where the Cisco IOS files reside (for example, d:\cpswinst\images).

Caution Make sure you set up your local PC as a TFTP server. If you do not, you cannot perform

the copy procedure. This caution applies to both TFTP and rcp.

Step 4 Establish a console session from your local PC (which is now configured as a TFTP server) to the

Cisco router by using one of these methods:

• Connect the PC com port to the Cisco 800 series router console port.

This is the recommended method. When you reload the Cisco 800 series router with the new image

in Step 10, you remain connected to the Cisco 800 series router.

• Establish a Telnet session from the PC to the Cisco 800 series router. If you choose to use Telnet,

your connection to the Cisco 800 series router will be lost when it is reloaded.

Caution Make sure that your PC is set up to communicate with the connected device through its

network port.

Step 5 Connect your PC’s LAN port to the corresponding LAN port on the Cisco 800 series router. If you are

making a direct connection to the Cisco 800 series router via Ethernet or Fast Ethernet, use an Ethernet

crossover cable. If connecting to the Cisco 800 series router via an Ethernet or Fast Ethernet hub or

Token Ring MAU (hub), use straight-through cable.

Note We recommend that you back up the router configuration before upgrading the

router software.

Step 6 At the prompt, enter the IP address of your PC, as shown in the following example:

Address or name of remote host [255.255.255.255]? 131.108.1.1

This is the IP address of your local PC, not that of the router.

Step 7 At the prompt, enter the filename of the Cisco IOS Release 12.0(7)XV image to be copied to the

router, as shown in the following example:

Source file name? aaa1167.bin

This example specifies the DOS image name of the IP feature set for Cisco 800 series routers (as shown

in Table 4 in the “Cisco 800 Series Routers Feature Packs” section on page 5).

Step 8 At the prompt, enter the destination UNIX image filename and press Enter.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Pas de commentaire

Cisco MEM800-8U12D Fiche technique Page 14