Cisco ISDN GW 3241 Manuel d'utilisateur Page 53

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 83
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 52
ISDN gateway administration
47
Allocating bandwidth for ISDN to IP calls
You can configure the dial plan to limit the bandwidth available for incoming ISDN calls. This is useful
where you want to limit the network resources available to individual calls. In this way, you can prevent any
one call using the resources to the extent that other incoming calls are prevented.
Allocating bandwidth for IP to ISDN calls
You can configure the dial plan to limit the bandwidth available for calls to particular numbers, or to
allocate more bandwidth to priority calls. As cost is an issue with calls to the ISDN network, you may want
to provide users with a list of prefixes that they can use to control the bandwidth for the calls they make. In
this way, rules enable users to select their own appropriate bandwidth for a call.
Specifying voice-only IP telephone calls
You can configure the dial plan to specify how IP telephone calls (that is voice-only calls) will be forwarded
to the ISDN network. Refer to “Using the ISDN gateway for voice-only calls” on page 47.
Setting up a gatekeeper
Some administrators like to use a gatekeeper to simplify management of IP telephony. In the case of the
ISDN gateway, the use of a gatekeeper can also simplify the management of the dial plan.
You can configure the ISDN gateway to use an H.323 gatekeeper, which can make it easier for ISDN
endpoint users to join conferences using directory numbers rather than requiring them to know the IP
address or host name of the MCU. This is especially useful where there are endpoints which do not allow
the dialling of IP addresses.
Using an H.323 gatekeeper can also make it easier for IP endpoint users to connect to ISDN end-points.
To configure the ISDN gateway to use a gatekeeper, go to
Settings > Gatekeeper.
For more information about configuring the ISDN gateway to use a gatekeeper, refer to the online help
topic “Configuring gatekeeper settings”.
Using the ISDN gateway for voice-only calls
The ISDN gateway can be used to forward voice-only IP calls to the ISDN network (the PSTN); likewise, it
can be used to forward voice-only ISDN calls from the PSTN to IP telephones on the IP network. If you
want to use the ISDN gateway to forward voice-only calls, there are two ways to configure this feature:
globally (that is by configuring unit-wide settings):
either
entirely as a voice-only gateway: where all IP calls and all ISDN calls are forwarded as voice-only
calls
Vue de la page 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 82 83

Commentaires sur ces manuels

Pas de commentaire