Cisco 3620 Guide d'installation Page 25

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 36
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 24
25
Step 7 Exit from interface configuration mode.
yourname (config-if)# exit
Step 8 Enter interface configuration mode on an Ethernet interface for connection to your PC. The following example is for
Ethernet interface 0 in chassis slot 1.
yourname (config)# interface FastEthernet 1/0
yourname (config-if)#
Step 9 Configure IP address 10.10.10.1 on this interface.
yourname (config-if)# ip address 10.10.10.1 255.255.255.0
Step 10 Enter the no shutdown command to enable the interface.
Step 11 Exit from interface configuration mode.
yourname (config-if)# exit
Step 12 Save the configuration by entering the copy running-config startup-config command.
Step 13 Exit from configuration mode.
yourname (config)# exit
Step 14 Continue with the “Start SDM” section.
Start SDM
To start SDM and begin the router configuration, perform the following procedure:
Step 1 Connect the Ethernet port of the PC to the FastEthernet 0/0 port of the router, using a crossover cable. If there is no
Ethernet adapter in chassis slot 0 of the router, connect the PC to the Ethernet port that you configured in the section
“If Your Router Has No Ethernet Adapter in Slot 0.”
Step 2 Open a web browser on the PC, and enter the following URL:
https://10.10.10.1/flash/sdm.shtml
Note https://... specifies that the Secure Socket Layer (SSL) protocol is used for a secure connection. If SSL is not
available, you can use http://... .
Step 3 Enter the username sdm and the password sdm in the dialog box.
Step 4 A window appears informing you that Verisign certifies that this is a Cisco application. Click Yes, or click Grant to
accept the certificate and proceed. Additional certificate windows appear if you are using Netscape; click Grant to
accept the certificates.
The SDM Launch page appears after a short time. (See Figure 21.) Leave this window open and wait for the next
window.
Vue de la page 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Commentaires sur ces manuels

Pas de commentaire